5 of the most important benefits of a water jet cutting equipment
There are many benefits that you can get from a water jet cutting equipment and it is important that you know all about it before you start using one or even if you are already in the verge of using the waterjet technology. In order for you to make a good decision regarding the waterjet technology for your business, it would be wise to read this article so that you can learn more about the benefits that it is able to provide.
The abrasive and pure waterjet cutting are the two kinds of methods that you need to know of when it comes to the water jet cutting systems. When you are going to cut soft materials such as paper or foam, it would be best to use the pure waterjet cutting method where only water stream is used for cutting. You need to include a granular abrasive in the water stream in order for the abrasive waterjet cutting method to work. Power will be added to the cutting stream by the granular abrasive that is why the abrasive waterjet cutting method is essential when you need to cut hard materials like ceramics or metal.
Here are some of the benefits that you need to know about the waterjet technology that can widen your understanding about it:
1. You do not have to worry about the material limitations
There are a lot of materials that you can cut with the use of the water jet cutting systems such as plastics, composites, rubber, ceramics, rock or stone, and metals. The waterjet cutting systems will be able to perform better if a granular abrasive is being added since it will be able to cut materials up to a 200mm thickness.
2. You do not have to worry about the HAZ or the heat affected zone
Due to its cold cutting method, there is no need for you to think about how you will affect the environment with the HAZ or the heat affected zone. The risks of burns will be eliminated so the operator’s safety is therefore guaranteed along with the fact that clean cuts are enabled due to cold cutting.
3. Materials are not being distorted
The heat exposure of the materials can be bypassed because of the cold cutting method and this is very much needed especially in handling hard materials such as metal where distortion is possible to happen. A burr-free cut, as well as a smooth finish, will be the result from this.
4. This particular method will not make you do some finishing process to your product.
The products will be provided with the highest cutting quality with accurate results that is why you do not need to worry about any finishing process that you might need to apply.
5. No need to worry about any hazardous waste
Environmentally friendly processes are being practiced nowadays that is why you need to be vigilant about this when doing your business.